Bradford White RG Gas Water Heater, Power Vent, 40000 BtuH Heating, Natural Gas, 1/2 Inch Gas Connection, 40 gal Tank, Spark to Pilot Ignition, 0.80 Recovery, 0.66 Energy Efficient, 3/4 Inch NPT Water Connection, 1600 deg F, Steel, Vitraglas, 57-5/16 Inch H x 20 Inch W x 27-7/8 Inch D, Includes: Temperature and Pressure Relief Valve
Our power vent (TTW) models are power vented for positive exhaust. They offer greater installation flexibility with the ability to vent through a wall or roof, with either 2 Inch or 3 Inch PVC, ABS or CPVC pipe. They offer an increased amount of hot water available at a usable temperature in less time than normal.
- Intelligent gas control with spark to pilot ignition system eliminates the constant burning pilot. This results in savings of pilot gas during standby periods (120 VAC)
- Enhanced performance - proprietary algorithms provide enhanced first hour delivery ratings and tighter temperature differentials
- Advanced temperature control system - microprocessor constantly monitors and controls burner operation to maintain consistent and accurate water temperature levels
- Intelligent diagnostics - an exclusive green LED light prompts the installer during start-up and provides ten different diagnostic codes to assist in troubleshooting
- Power vented water heater - designed for installations where atmospheric units cannot be used. Exhaust gases are vented under positive pressure directly out of the building through the roof or the wall
- Powerful blower motor - our significantly quiet design has greater resistance to outside winds and the power to vent in many difficult venting situations. Ten foot power cord- included (120 VAC)
- Horizontal and vertical venting - PVC, ABS or CPVC (maximum equivalent vent length on reverse side)
- Advanced ScreenLok technology flame arrestor design - flame arrestor is designed to prevent ignition of flammable vapor outside of the water heater
- Flammable vapor sensor - electronic sensor prevents burner operation if flammable vapors are detected. The sensor will also prevent operation if there is ongoing flammable vapor burn inside the combustion chamber
- Maintenance-free - no regular cleaning of air inlet openings or flame arrestor is required under normal conditions
- Sight window - offers a view into the combustion chamber to observe the operation of the pilot and burner
- Factory-installed hydrojet total performance system - cold water inlet sediment reducing device helps prevent sediment build-up in tank. This increases first hour delivery, while minimizing temperature build-up at top of tank
- Vitraglas lining - Bradford white tanks are lined with an exclusively engineered enamel formula that provides superior tank protection from the highly corrosive effects of hot water
- Non-CFC foam insulation - covers the sides and top, reducing the amount of heat loss. This results in less energy consumption, improved operation efficiencies, and jacket rigidity
- Factory-installed heat traps - design incorporates a flexible disk that reduces heat loss in piping and eliminates the potential for noise generation
- Low restriction brass drain valve - durable tamper-proof design
Standard/Approvals: CSA Certified, Energy Star Listed, NAECA Compliant, ASHRAE 90.1b Certified, C.E.C. Listed, ANSI Z-21.10.1 and ANSI Z-21.10.30
Application: Plumbing and Residential